Glass Microfiber Cartridges
GMF Series for general filtration & high flow rates at 99.98% efficiency
Product Information
- AMBF’s Glass Microfiber cartridges offer a wide array of retention ratings from .5 to 7 microns
- All Glass Microfiber cartridges are produced in-house on the most modern equipment
- Complete in-house testing guarantees a superior and consistent product
- We offer all end cap configurations to fit your applications and housings
- Cartridges have an excellent dirt holding capacity with low flow resistance
- Acrylic bonded media for excellent chemical resistance
- Each cartridge has a non-shedding final layer laminated on the media before pleating
- Media grades available for FDA Title 21 for food and potable water contact
- Hydrophobic media can be produced if required for your applications
- Cartridges are constructed in a clean room environment
- Cartridges may be ordered as final rinsed with 18 mega ohm water
Toxicity | Purity |
---|---|
AMBF’s Cartridges are manufactured with no additives or other manufacturing agents. | Cartridges are Free of Surfactants, Resins, Binders and Adhesives |
Sterilization | |
Multiple Autoclaving for 30 Minutes at 250°F (121°C) under no End Load Conditions. In-line Steam Sterilization is not recommended. May be In-line Sanitized with Hot Water at 180°F (82°C) for 1 hour. |
Product Specifications
Product Specifications | |
---|---|
Retention Ratings | .5, .8, 1.2, 2.0, 2.7, 4.0, 6.4 & 7.0 micron |
Media | Acrylic bonded glass microfiber |
Support Media | Polypropylene |
End Caps | Polypropylene |
Center Core | Polypropylene |
Outer Support Cage | Polypropylene |
Maximum Operating Temperature | 180°F |
Nominal Diameter |
O.D. - 2.7" I.D. - 1" center |
Lengths | 10, 20, 30, & 40 inch |
Maximum Differential Pressure | 45 psid |
Building a Product Number
Glass Microfiber | Micron | Cartridge Length |
Core Material |
End Cap (Help?) | Gasket/O-Ring | 18 Mega Ohm Rinse | |
---|---|---|---|---|---|---|---|
GMF | 1.2 | 3 | E | 2 | B | R | |
GMF |
.5 .8 1.2 2.0 |
2.7 4.0 6.4 7.0 |
3 = 10 5 = 20 7 = 30 9 = 40 |
E = Polypropylene |
2 = 222/Fin 4 = 222/Flat 5 = 226/Flat 6 = 226/Fin 9 = Flat Gasket |
B = Buna V = Viton® T = Teflon® S = Silicone N = Neoprene D = EPDM |
R |