Polyethersulfone Membrane Cartridges
PES Series for Electronics, DI Water, Chemical & Beverage Filtration
Product Information
- AMBF’s (PES), Polyethersulfone cartridges offer a wide array of micron ratings from .1 to 5 microns
- All Polyethersulfone cartridges are produced in-house on the most modern equipment available
- Complete in-house testing guarantees a superior and consistent product
- Cartridges have excellent dirt holding capacity with low flow resistance
- Naturally hydrophilic media does not need wetted before use
- We offer all end cap configurations to fit your applications and housings
- Polyethersulfone media is excellent for its low protein binding and chemical compatibility
- Cartridges are manufactured to meet FDA Title 21 for food contact applications
- Cartridges are constructed in a clean room environment
- Cartridges may be ordered as final rinsed with 18 mega ohm water
Polyethersulfone Membrane Cartridges
Download Cut Sheet| Toxicity | Purity |
|---|---|
| AMBF’s Cartridges are manufactured with no additives or other manufacturing agents. We guarantee all materials used in the production meet FDA Title 21 of the Code of Federal Regulations 174.5 and 177.1520. | Cartridges are Free of Surfactants, Resins, Binders and Adhesives |
| Sterilization | |
| Multiple Autoclaving for 30 Minutes at 250°F (121°C) under no End Load Conditions. In-line Steam Sterilization is not recommended. May be In-line Sanitized with Hot Water at 180°F (82°C) for 1 hour. | |
Product Specifications
| Product Specifications | |
|---|---|
| Retention Ratings | .1, .22, .45, .6, .8, 1.2, & 5 micron |
| Membrane | Polyethersulfone |
| Support Media | Polypropylene |
| End Caps | Polypropylene |
| Center Core | Polypropylene |
| Outer Support Cage | Polypropylene |
| Maximum Operating Temperature | 175°F |
| Nominal Diameter |
O.D. - 2.7" I.D. - 1" center |
| Lengths | 10, 20, 30, & 40 inch |
| Maximum Differential Pressure | 45 psid |
Building a Product Number
| Polyethersulfone | Micron | Cartridge Length |
Core Material |
End Cap (Help?) | Gasket/O-Ring | 18 Mega Ohm Rinse |
|---|---|---|---|---|---|---|
| PES | .1 | 3 | E | 2 | B | R |
| PES |
.1 .22 .45 .60 .80 1.2 5.0 |
3 = 10 5 = 20 7 = 30 9 = 40 |
E = Polypropylene |
2 = 222/Fin 4 = 222/Flat 5 = 226/Flat 6 = 226/Fin 9 = Flat Gasket |
B = Buna V = Viton® T = Teflon® S = Silicone N = Neoprene D = EPDM |
R |